Unilocker has a unique “Uniframe” construction. The 16 gauge locker frame is made from a single sheet of steel, punched, formed and pressed into a finished solid frame. No welds. This frame has a lifetime warranty.
One Piece Frame
Integral Door Hinge
The Unilocker premium locker is constructed with no extra metal piece for a door hinge. Instead the base and panel each have a hinge component connected with a steel pin. This minimizes wear and tear as our lockers have an integral door hinge.
Unilocker premium lockers use on average 30% more steel than standard lockers. Our doors are constructed using a stronger 16 gauge steel vs. standard 20 gauge lockers. Our locker bodies use 20 gauge steel vs. standard 24 gauge lockers.
All backs, sides are standard 20 gauge prepainted steel. Top bottoms are made from 20 gauge steel (16 Gauge optional), fitted into the Unilocker frame at front and riveted to back.
Unilocker frame has 6 integral hinges. This allows for single tier, double tier, triple tier and 6 tier. All from the same solid one piece 16 gauge frame. Lockers are 12″ wide 72″ high 15″ or 18″ deep. Padlock, key locks or built-in combination locks available.
End lockers are made with a 16 gauge end side and back panel which acts as an end panel, riveted to the end locker, and painted to match the frame colour. Easy to replace where damage or vandalism occurs. Sloping tops, bases and filler trims also available.
Pocket and Door Pull
The door pull is made from the 16 gauge skin of the door, pressed to a finished door handle with rolled edge. No welds or fasteners used. The pocket is stainless steel – inset into the door skin.